Release : 1.1f 657 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.10 area-stub
This command specifies an area as a stub area and other parameters related to that area and the
no form of the command removes an area or converts stub/nssa to normal area.
area <area-id> stub [no-summary]
no area <area-id> [{ stub | nssa }]
Syntax Description
area-id - Area associated with the OSPF address range. It is specified as an IP address
stub - Stub area. If the area type is no-summary, the router will neither originate nor propagate
summary LSAs into the stub area
nssa - Not So Stubby Area
Mode
Router Configuration Mode
Example
SMIS(config-router)# area 10.0.0.1 stub
The command must be configured on all routers and access servers in the stub area.
Related Commands
area-default cost – Specifies a cost for the default summary route sent into a stub or
NSSA
area - range – Consolidates and summarizes routes at an area boundary
ip ospf authentication – Specifies the authentication type for an interface
To Next Page
Loading...
