Release : 1.1f 576 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
23.4 set ip pim rp-threshold
This command sets the threshold at which RP (Rendezvous Point) initiates switching to source
specific shortest path tree.
set ip pim rp-threshold <0-2147483647(number of reg packets)>
Mode
Global Configuration Mode
Defaults
0
Example
iss (config)# set ip pim rp-threshold 50
To switch to SPT, this threshold must be configured and this switching is based on the received
number of registered packets.
Related Command
show ipv6 pim thresholds – Displays threshold configured for SPT, RP thresholds, rate
limit values for both SM and DM
To Next Page
Loading...
