Supermicro SSE-G48-TG4 - Show Ip Pim Mroute

Release : 1.1f 569 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
22.33 show ip pim mroute
This command displays the PIM multicast information.
show ip pim mroute [ {compid(1-255) | group-address | source-address }
summary]
Syntax Description
compid - Component ID
group-address - Indicates the PIM multicast group address using the listed RP
source-address - The network address which identifies the sources for which this entry
contains multicast routing information
summary - Summary of PIM mroute information
Mode
Privileged EXEC Mode
Example
SMIS# show ip pim mroute
IP Multicast Routing Table
--------------------------
Route Flags S: SPT Bit W: Wild Card Bit R: RPT Bit
Timers: Uptime/Expires
Interface State: Interface, State/Mode
PIM Multicast Routing Table for Component 1
(*, 224.1.0.0), 00:04:35/--- , RP:12.0.0.1
Incoming Interface: vlan1, RPF nbr: NULL, Route Flags: WR
Outgoing InterfaceList:
vlan2, Forwarding/Sparse, 00:04:35/---
(12.0.0.30,224.1.0.0), 00:00:04/00:03:26
Incoming Interface : vlan1, RPF nbr : NULL, Route Flags : S
Outgoing InterfaceList
vlan2, Forwarding/Sparse, 00:00:04/---
SMIS# show ip pim mroute 1 summary
IP Multicast Routing Table