Release : 1.1f 412 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
16.2.2 ip dhcp server
This command set the IP address of the DHCP server. The Relay Agent will now start forwarding
the packets from the client to a specific DHCP server. The no form of the command deletes the
DHCP server IP address.
ip dhcp server <ip address>
no ip dhcp server <ip address>
Mode
Global Configuration Mode
Defaults
Disabled
Example
SMIS(config)# ip dhcp server 12.0.0.1
Only when the relay agent is enabled, the Relay Agent shall forward the packets from the client to
a specific DHCP server.
Related Commands
show ip dhcp relay information - Displays the DHCP relay information
show dhcp server - Displays the DHCP server information
To Next Page
Loading...
