Release : 1.1f 536 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
22.2 set ip pim threshold
This command specifies the SPT group or source threshold when exceeded, switching to shortest
path tree is initiated. To switch to SPT, the threshold MUST be configured.
set ip pim threshold { spt-grp | spt-src } < number of packets(0-
2147483647)>
Syntax Description
spt-grp - The threshold of data rate for any group when exceeded, source specific counters
are initiated for that particular group. It is based on number of bits per second.
spt-src - The switching to Shortest Path Tree is initiated, when the threshold of data rate for
any source is exceeded. It is based on number of bits per second.
number of packets - Number of packets
Mode
Global Configuration Mode
Defaults
0
Example
iss (config)# set ip pim threshold spt-grp 50
Related Command
show ip pim thresholds – Displays threshold configured for SPT, RP thresholds, rate limit
values for both SM
To Next Page
Loading...
