Release : 1.1f 832 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.5 area - translation-role
This command configures the translation role for NSSA. The no form of the command configures
the default translation role for the NSSA.
area <area-id> translation-role { always | candidate }
no area <area-id> translation-role
Syntax Description
area-id - A 32 bit integer
translation-role - An NSSA Border router's ability to perform NSSA
Translation of Type-7 LSAs to Type-5 LSAs
Mode
Router Configuration Mode
Defaults
translation-role - candidate
Example
SMIS(config-router)# area 0.0.0.1 translation-role always
When the translator role is set to always, the Type-7 LSAs are always translated into
Type-5 LSAs.
When translator role is set to candidate, an NSSA border router participates in the
translator election process.
Related Command
show ipv6 ospf areas – Displays the Area Table
To Next Page
Loading...
