Supermicro SSE-G48-TG4 - Loop-Protect Receive-Action

Release : 1.1f 951 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
34.4 loop-protect receive-action
When a loop is detected switch disables the port from which the loop protection packets
originated. This command can be used to configure not to disable the port when loop is detected.
The no form of this command resets the receive action to the default value send-disable.
loop-protect receive-action {send-disable| no-disable}
no loop-protect receive-action
Syntax Description
send-disable – disables the port from which the loop protection packets originated are getting
looped
no-disable – loop detected ports are not disabled
Mode
Global Configuration Mode
Defaults
send-disable
Example
SMIS(config)# loop-protect receive-action no-disable
Related Commands
show loop-protect – Displays the loop protection receive action information.