Release : 1.1f 894 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
32.5 class
This command defines a traffic classification for the policy to act. The class-map-number that is
specified in the policy map ties the characteristics for that class to the class map and its match
criteria, as configured by using the class-map global configuration command. On execution of the
class command, the switch enters the policy-map class configuration mode
The no form of this command un-maps the class-map from the current policy-map configuration.
class <class-map-number(1-65535)>
no class <class-map-number(1-65535)>
Syntax Description
class-map-number - Class Map Number
Mode
Policy-Map Configuration Mode
Example
iss (config-pmap)# class 5
Differentiated services must have been enabled in the device.
The policy-map global configuration command must be executed prior to using the class
command. After a policy map is specified, the user can either configure a policy for new
classes or modify a policy for any existing classes in that policy map.
The following configuration commands are available from the policy map class
configuration mode
- set cos
- police
Related Commands
policy-map - Enters the policy map configuration mode
show policy-map - Displays the QoS policy maps
To Next Page
Loading...
