Release : 1.1f 662 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.14 area - range
This command consolidates and summarizes routes at an area boundary. The no form of the
command deletes the Summary Address.
area <AreaId> range <Network> <Mask> {summary | Type7} [{advertise |
notadvertise}] [tag <value>]
no area <AreaId> range <Network> <Mask>
Syntax Description
Area-id - Area associated with the OSPF address range. It is specified as an IP address
range - OSPF address range
Network - The IP address of the Net indicated by the range
Mask - The subnet mask that pertains to the range
summary - Summary LSAs
Type7 - Type-7 LSA
advertise - When set to advertise and associated areaId is 0.0.0.0, aggregated Type-5 are
generated. Otherwise if associated areaId is x.x.x.x (other than 0.0.0.0) aggregated Type-7 is
generated in NSSA x.x.x.x
not-advertise - When set to doNotAdvertise (2) and associated areaId is 0.0.0.0, Type-5 is
not generated for the specified range, while aggregated Type-7 are generated in all attached
NSSA. While if associated areaId is x.x.x.x(other than 0.0.0.0), Type-7 are not generated in
NSSA x.x.x.x for the specified range
tag - The Tag Type describes whether Tags will be automatically generated or will be manually
configured
Mode
Router Configuration Mode
Defaults
tag - 2
Example
SMIS(config-router)# area 10.0.0.1 range 10.0.0.0 255.0.0.0 summary
advertise tag 10
The mask indicates the range of addresses being described by the particular route.
To Next Page
Loading...
