Release : 1.1f 430 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
16.3.10 dns-server
This command is used to specify the IP address of a DNS server that is available to a DHCP
client. The no form of the command deletes the DNS server from the DHCP server configuration
parameters.
dns-server <ip address>
no dns-server
Mode
DHCP Pool Configuration Mode
Example
SMIS(dhcp-config)# dns-server 20.0.0.1
If DNS IP servers are not configured for a DHCP client, the client cannot correlate host
names to IP addresses.
The configuration of this command will take effect only after configuring the network
address pool using network command.
Related Commands
service dhcp-server - Enables the DHCP server
show ip dhcp server information - Displays the server information
show ip dhcp server pools - Displays the DHCP server pools
show ip dhcp server binding - Displays the DHCP server binding information
show ip dhcp server statistics - Displays the DHCP server statistics
network - Configures the Network IP for the DHCP Pool
To Next Page
Loading...
