Release : 1.1f 899 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
32.10 show policy-map
This command displays the quality of service (QoS) policy maps, which defines the classification
criteria for the incoming traffic. Policy maps can include polices that specify the bandwidth
limitations and the action to take if the limits are exceeded.
show policy-map [<policy-map-num(1-65535)> [class <class-map-num(1-
65535)>]]
Syntax Description
policy-map-num - Policy map number
class - Class map number
Mode
Privileged/User EXEC Mode
Example
SMIS# show policy-map 24
DiffServ Configurations:
------------------------
Quality of Service has been enabled
Policy Map 24 is not active
Class Map: 20
----------------
Protocol : 255
In Profile Entry
----------------
In profile action : policed-precedence 5
Out Profile Entry
-----------------
Metering on
burst bytes/token size : 6
Refresh count : 1000
Out profile action : drop
No Match Entry
--------------
No match action : policed-precedence 5
To Next Page
Loading...
