Release : 1.1f 196 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
9.1 spanning-tree mode
This command sets the spanning tree operating mode.
spanning-tree mode {mst|rst}
Syntax Description
mst - MSTP configuration
rst - RSTP configuration
Mode
Global Configuration Mode
Defaults
mst
Example
SMIS(config)#spanning-tree mode rst
When ISS boots up, Spanning Tree is enabled by default with MSTP operating in the switch.
This command only starts and enables the spanning tree mode. However port-roles and
states will be computed only after enabling the spanning tree.
If the user-input for the spanning-tree mode is different from the current mode of operation,
then ISS will shutdown the operational spanning-tree and start the spanning-tree as per user-
input.
Related Commands
show spanning-tree - Detail - Displays detailed spanning tree information
show spanning-tree - Active - Displays spanning tree information of active ports
To Next Page
Loading...
