Release : 1.1f 612 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
24.5 vrrp - preempt
This command enables the pre-emption of state change from either Backup to Master or vice
versa based on the election process. The no form of the command disables the preempt mode
vrrp <vrid(1-255)> preempt
no vrrp <vrid(1-255)> preempt
Syntax Description
vrid - Virtual Router ID
preempt - Enables preemption of VRRP router states
Mode
VRRP Interface Configuration Mode
Defaults
Pre-emption is enabled by default
Example
SMIS(config-vrrp-if)# vrrp 5 preempt
The command vrrp <vrid(1-255)> ipv4 <ip address> must be entered for the current
interface (with the proper vrid) before the execution of this command.
Related Commands
router vrrp – Enables VRRP in the router
show vrrp – Displays the VRRP status information
To Next Page
Loading...
