Release : 1.1f 750 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
27.42 show ip bgp
This command displays the BGP related information.
show ip bgp {[neighbor [<peer-addr>]] | rib}
Syntax Description
neighbor - IP address of the neighbor
rib - BGP local RIB (Routing Information Base)
Mode
Privileged EXEC Mode
Example
SMIS# show ip bgp neighbor 10.0.0.2
BGP neighbor is 10.0.0.2, remote AS 200, external link
BGP version 4, remote router ID 10.0.0.2
BGP state = Established, up for 21 minutes 26 seconds
Rcvd update before 0 secs, hold time is 120, keepalive
interval is 24 secs
Neighbors Capability:
Route-Refresh: Advertised and received
Address family IPv4 Unicast: Advertised and received
Received 44 messages, 0 Updates
Sent 56 messages, 5 Updates
Route refresh: Received 0, sent 0.
Minimum time between advertisement runs is 300 seconds
Connections established 1 time(s)
Local host: 10.0.0.1, Local port: 179
Foreign host: 10.0.0.2, Foreign port: 49152
Last Error: Code 0, SubCode 0.
BGP Speaker Local AS number must be configured.
Related Commands
router bgp – Sets the AS number of the BGP Speaker
bgp router-id – Configures the BGP Identifier of the BGP Speaker
neighbor - shutdown – Disables the Peer session
To Next Page
Loading...
