Release : 1.1f 632 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
25.10 route-tag
This command sets the route tag to be used for redistributed routes and the no form of the
command sets the route tag to its default value 0.
route-tag <tag-value>
no route-tag
Syntax
<tag-value> - Any number between 1 to 65535
Mode
Router Configuration Mode
Defaults
0
Example
SMIS(config-router)# route-tag 1
Related Commands
redistribute – Enables redistribution of corresponding protocol routes into RIP
show ip rip – Displays IP RIP protocol database or statistics
To Next Page
Loading...
