Supermicro SSE-G48-TG4 - Snmp Trap Link-Status

Release : 1.1f 111 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
3.73 snmp trap link-status
This command enables trap generation on either the physical interface or the port-channel
interface. The no form of this command disables trap generation on the respective interface.
snmp trap link-status
no snmp trap link-status
Mode
Interface Configuration Mode
Defaults
SNMP trap link status is enabled by default
Example
SMIS(config-if)# snmp trap link-status
Related Command
show interfaces - Displays the interface status and configuration