Release : 1.1f 856 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.25 ipv6 ospf demand-circuit
This command configures OSPFv3 to treat the interface as an OSPFv3 demand circuit. It
indicates whether Demand OSPFv3 procedures (hello suppression to FULL neighbors and
setting the DoNotAge flag on propagated LSAs) must be performed on the configured interface.
The no form of the command disables the demand circuit on an interface.
ipv6 ospf demand-circuit
no ipv6 ospf demand-circuit
Mode
Interface Configuration Mode
Defaults
Disabled
Example
SMIS(config-if)# ipv6 ospf demand-circuit
The routing support for demand routing must have been enabled (using the demandextensions
command) prior to the execution of this command.
Related Commands
demand-extensions – Enables routing support for demand routing
show ipv6 ospf interface – Displays the OSPFv3-related interface information
To Next Page
Loading...
