Release : 1.1f 677 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.26 ip ospf hello-interval
This command specifies the interval between hello packets sent on the interface and the no form
of the command sets default value for, interval between hello packets sent on the interface.
ip ospf hello-interval <seconds (1 - 65535)>
no ip ospf hello-interval
Mode
Interface Configuration Mode
Defaults
10
Example
SMIS(config-if)# ip ospf hello-interval 75
This value must be the same for all routers attached to a common network.
Related Commands
ip ospf retransmit-interval – Specifies the time between link-state advertisement
(LSA) retransmissions for adjacencies belonging to the interface
ip ospf dead-interval – Sets the interval at which hello packets must not be seen before
neighbors declare the router down
ip ospf transmit-delay – Sets the estimated time it takes to transmit a link state update
packet on the interface
show ip ospf interface – Displays OSPF interface information
To Next Page
Loading...
