Release : 1.1f 866 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.35 ipv6 ospf passive-interface
This command configures an OSPFv3 interface to be Passive. The execution of the command
results in suppressing OSPFv3 protocol packets traffic on this interface. The no form of the
command configures an OSPFv3 interface to be non-passive.
ipv6 ospf passive-interface
no ipv6 ospf passive-interface
Mode
Interface Configuration Mode
Defaults
Disabled
Example
SMIS(config-if)# ipv6 ospf passive-interface
Related Command
show ipv6 ospf interface – Displays the OSPFv3 related interface information
To Next Page
Loading...
