Release : 1.1f 420 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
16.3.2 ip dhcp pool
This command creates a DHCP server address pool and places the user in the DHCP pool
configuration mode.
The no form of the command deletes the DHCP server address pool.
ip dhcp pool <index (1-2147483647)>
no ip dhcp pool <index (1-2147483647)>
Syntax Description
Index - Pool Number
Mode
Global Configuration Mode
Defaults
Address pools are not created by default
Example
iss (config)# ip dhcp pool 1
On execution of this command, the configuration mode changes to DHCP pool
configuration mode identified by the (config-dhcp)# prompt. In this mode, the
administrator can configure pool parameters.
Related Commands
network - Sets the network number and mask in DHCP server configuration parameters
excluded-address - Creates an excluded pool to prevent DHCP from assigning certain
addresses
domain-name - Sets the domain name in the DHCP server configuration parameters
dns-server - Specifies the IP address of a DNS server
netbios-name-server - Sets the NetBIOS (WINS) name servers in the DHCP server
configuration parameters
netbios-node-type - Sets the NetBios node type in the DHCP server configuration
parameters
default-router - Sets the default router in the DHCP server configuration parameters
To Next Page
Loading...
