Release : 1.1f 109 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
3.71 storm-control
This command sets the storm control rate for broadcast, multicast and DLF packets and the no
form of the command sets storm control rate for broadcast, multicast and DLF packets to the
default value.
storm-control { broadcast |multicast | dlf } level <rate-value>
no storm-control { broadcast |multicast | dlf } level
Syntax Description
broadcast - Broadcast packets
multicast - Multicast packets
dlf - Unicast packets
level - Storm-control suppression level as a total number of packets per second.
Mode
Interface Configuration Mode
Defaults
Broadcast, multicast, and dlf storm control are disabled.
Example
SMIS(config-if)# storm-control broadcast level 1000
The rate must be specified in terms of packets per second.
Storm control is supported only on physical interfaces
Related Command
show interfaces - Displays the interface status and configuration
To Next Page
Loading...
