Supermicro SSE-G48-TG4 - Ipv6 Nd Managed-Config Flag

Release : 1.1f 782 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
28.8 ipv6 nd managed-config flag
This command sets the 'Managed config flag' which allows the host to use DHCP for address
configuration. The no form of the command resets the 'Managed config flag' which in turn does
not allow the host to use DHCP for address configuration.
ipv6 nd managed-config flag
no ipv6 nd managed-config flag
Mode
Interface Configuration Mode
Example
SMIS(config-if)# ipv6 nd managed-config flag
Related Command
no ipv6 nd suppress-ra – Enables IPv6 router advertisement