Release : 1.1f 892 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
32.3 policy-map
This command is used to enter the policy-map configuration mode
In the policy-map configuration mode the user can create or modify a policy map. The no form of
this command deletes an existing policy map and returns to the global configuration mode
policy-map <policy-map-number(1-65535)>
no policy-map <policy-map-number(1-65535)>
Syntax Description
policy-map-number - QoS Policy map number
Mode
Global Configuration Mode
Example
SMIS(config)# policy-map 6
Differentiated services must have been enabled in the device.
The following two commands are available from the policy-map configuration mode
- class
- exit - Exits from the policy map configuration mode and returns to the global
configuration mode
Related Command
show policy-map - Displays quality of service (QoS) policy maps
To Next Page
Loading...
