Release : 1.1f 655 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.8 area-default cost
This command specifies a cost for the default summary route sent into a stub or NSSA and the
no form of the command removes the assigned default route cost.
area <area-id> default-cost <cost> [tos <tos value(0-30)>]
no area <area-id> default-cost [tos <tos value (0-30)>]
Syntax Description
area-id - Area associated with the OSPF address range. It is specified as an IP address
default-cost - Cost for the default summary route used for a stub area
tos - Type of Service of the route being configured
Mode
Router Configuration Mode
Defaults
default-cost - 10
tos - 0
Example
SMIS(config-router)# area 10.0.0.1 default-cost 5
A default cost can be defined only for a valid area.
tos can be configured only if the code is compiled with TOS Support
Related Commands
area-stub – Specifies an area as a stub area and other parameters related to that area
area - range – Consolidates and summarizes routes at an area boundary
ip ospf cost – Specifies the cost of sending a packet on an interface
ip ospf authentication – Specifies the authentication type for an interface
To Next Page
Loading...
