Supermicro SSE-G48-TG4 - Ip Igmp Last-Member-Query-Interval

Release : 1.1f 504 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
19.8 ip igmp last-member-query-interval
This command sets the IGMP last member query interval for the interface and the no form of the
command sets the last member query interval to the default value.
ip igmp last-member-query-interval <value(1-255)>
no ip igmp last-member-query-interval
Mode
Interface Configuration Mode
Defaults
10
Example
SMIS(config-if)# ip igmp last-member-query-interval 100
The igmp version on this interface must be set to 2.
Related Commands
show ip igmp interface - Displays the interface configuration of IGMP