Release : 1.1f 75 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
3.37 ntp broadcast
This command enables the switch to accept NTP broadcast messages sent by NTP broadcast
servers. This command also enables the authentication for the received NTP broadcast
messages if authentication option is given.
The no form of this command configures the switch not to accept NTP broadcast messages.
ntp broadcast [authentication]
no ntp broadcast
Syntax Description
authentication – Accepts NTP broadcasts from NTP severs after the authentication
Mode
Global Configuration Mode
Example
SMIS(config)# ntp broadcast authentication
Related Command
ntp server -
Configures NTP server IP address, key, interval and preference
ntp enable – Enables NTP
To Next Page
Loading...
