Supermicro SSE-G48-TG4 - Exit-Overflow-Interval

Release : 1.1f 852 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.21 exit-overflow-interval
This command sets the number of seconds after which a router will attempt to leave the Overflow
State.
exit-overflow-interval <interval>
Mode
Router Configuration Mode
Defaults
interval - 0
Example
SMIS(config-router)# exit-overflow-interval 10
Related Command
show ipv6 ospf - General Information – Displays general information about the
OSPFv3 routing process