Release : 1.1f 36 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
information.
show flow-control This command displays the flow-control
information.
show transceiver This command displays the information about
fiber optic transceiver modules.
show meminfo This command displays the memory status and
utilization.
System Commands
Command Description
device name This command configures the switch name
string.
system location This command configures the switch location
information string.
system contact This command configures the switch contact
information.
set boot-up
This command configures the next bootup
firmware image selection.
reload This command restarts the switch.
reset-to-factory-defaults This command resets the switch to factory
defaults configuration.
mac-address-table aging-time This command sets the maximum age of a
dynamically learnt entry in the MAC address
table.
copy debugg-logging This command writes the debug logs to a
remote site or to external USB memory.
debug-logging This command configures where debug logs
are to be displayed and the no form of the
command displays debug logs in the console.
no startup-config This command makes no configuration file will
be loaded in next reboots of the switch.
show system information This command displays system information.
show version This command displays hardware and firmware
version numbers.
To Next Page
Loading...
