Release : 1.1f 667 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.17 redist-config
This command configures the information to be applied to routes learnt from RTM and the no
form of the command deletes the information applied to routes learnt from RTM.
redist-config <Network> <Mask> [metric-value <metric (1 - 16777215)>]
[metrictype {asExttype1 | asExttype2}] [tag <tag-value>}
no redist-config <Network> <Mask>
Syntax Description
Network - IP Address of the Destination route
Mask - Mask of the Destination route
metric-value - The Metric value applied to the route before it is advertised into the OSPF
Domain
metric-type - The Metric Type applied to the route before it is advertised into the OSPF
Domain
tag - The Tag Type describes whether Tags will be automatically generated or will be manually
configured
Mode
Router Configuration Mode
Defaults
metric-value - 10
metric-type - asExttype2
tag - manual
Example
SMIS(config-router)# redist-config 10.0.0.0 255.0.0.0 metricvalue
100 metric-type asExttype1 tag 10
tag <tag-value>: This is not used by OSPF protocol itself. It may be used to communicate
information between AS boundary routers. The precise nature of this information is outside the
scope of OSPF. If tags are manually configured, the futospfRRDRouteTag MIB has to be set with
the Tag value needed.
Related Command
To Next Page
Loading...
