Release : 1.1f 250 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
10.4 set nas-id
This command sets the dot1x network access server id.
set nas-id <identifier>
Syntax Description
identifier - It is a string length of 16 that specifies dot1x network access server ID
Mode
Global Configuration Mode
Defaults
fsNas1
Example
SMIS(config)#set nas-id Identifier
Network Access Server Identifier is set in the RADIUS packets sent to the Remote Authentication
Server.
Related Command
show dot1x - Displays dot1x information
To Next Page
Loading...
