Release : 1.1f 703 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
27.1 router bgp
This command sets the AS number of the BGP Speaker. The no form of the command brings the
BGP Speaker Global Admin status DOWN and resets the AS number of the BGP Speaker.
router bgp <AS no(1-65535)>
no router bgp
Syntax Description
AS no - Autonomous system number that identifies the BGP router to other routers and tags the
routing information passed along
Mode
Global Configuration Mode
Defaults
0
Example
SMIS(config)# router bgp 100
The command makes the BGP speaker Global Admin Status ACTIVE.
Related Commands
ip bgp dampening – Configures the Dampening Parameters
ip bgp overlap-policy – Configures the Overlap Route policy for the BGP Speaker
ip bgp synchronization – Enables synchronization between BGP and IGP
bgp router-id – Configures the BGP Identifier of the BGP Speaker
bgp default local-preference – Configures the Default Local Preference value
neighbor - remote-as – Creates a Peer and initiates the connection to the peer
neighbor - ebgp-multihop – Enables BGP to establish connection with external peers
neighbor - next-hop-self – Enables BGP to send itself as the next hop for advertised
routes
neighbor - interval – Configures neighbor interval
neighbor - timers– Configures neighbor KeepAlive Time and Hold Time Intervals
neighbor - shutdown – Disables the Peer session
neighbor - send-community – Enables advertisement of community attributes to
To Next Page
Loading...
