Supermicro SSE-G48-TG4 - Lldp Tlv-Select Basic-Tlv

Release : 1.1f 973 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
36.12 lldp tlv-select basic-tlv
This command configures basic tlv transmission on interface. It enables the transmission of given
tlv on any interface.
The no form of this command disables the transmission of given tlv on any interface.
lldp tlv-select basic-tlv { [port-descr] [sys-name] [sys-descr] [sys-
capab] [mgmt-addr {all | ipv4 <ucast_addr> | ipv6 <ip6_addr>}]}
no lldp tlv-select basic-tlv { [port-descr] [sys-name] [sys-descr]
[sys-capab] [mgmt-addr {all | ipv4 <ucast_addr> | ipv6 <ip6_addr>}]}
Syntax Description
port-descr – Enables port description tlv transmission
sys-name - Enables system name tlv transmission
sys-descr - Enables system description tlv transmission
sys-capab - Enables system capabilities tlv transmission
mgmt-addr all - Enables transmission of all management address information
mgmt-addr ipv4 - Enables transmission of given IPv4 management address information
mgmt-addr ipv6 - Enables transmission of given IPv6 management address information
Mode
Interface Configuration Mode
Defaults
Disabled
Example
SMIS(config-if)# lldp tlv-select basic-tlv sys-name sys-descr sys-capab
Related Commands
show lldp local – Displays the LLDP local interface information.