Release : 1.1f 851 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.20 as-external lsdb-limit
This command sets the maximum number of non-default AS-external-LSA entries that can be
stored in the link-state database. If the value is -1, then there is no limit.
as-external lsdb-limit <lsdb-limit (-1 - 0x7fffffff)>
Mode
Router Configuration Mode
Defaults
lsdb-limit - -1
Example
SMIS(config-router)# as-external lsdb-limit 10
When the number of non-default AS-external-LSAs in a router's link-state database reaches the
configured limit, the router enters Overflow- State. The router never holds more than the
configured non-default AS-external-LSAs in its database.
The LSDB limit MUST be set identically in all routers attached to the OSPFv3 backbone and/or
any regular OSPFv3 area. (i.e. OSPFv3 stub areas and NSSAs are excluded).
Related Commands
show ipv6 ospf - General Information – Displays general information about the
OSPFv3 routing process
exit-overflow-interval – Sets the number of seconds after which a router will attempt to
leave the Overflow State
To Next Page
Loading...
