Release : 1.1f 359 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
15.21 port protocol-vlan
This command enables port protocol based VLANs. The no form of the command disables port
Protocol based VLANs.
port protocol-vlan
no port protocol-vlan
Mode
Interface Configuration Mode
Defaults
Enabled
Example
SMIS(config-if)# port protocol-vlan
The value enable indicates that the VLAN classification on this port is port and protocol
based as long as the port and protocol based classification is enabled globally for the
device.
Related Command
show vlan port config - Displays the VLAN related parameters specific for ports
To Next Page
Loading...
