Supermicro SSE-G48-TG4 - Show Ip Pim Rp-Candidate

Release : 1.1f 563 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
22.27 show ip pim rp-candidate
This command displays the candidate RP information.
show ip pim rp-candidate [ComponentId <1-255>]
Syntax Description
ComponentId - Component ID
Mode
Privileged EXEC Mode
Example
SMIS# show ip pim rp-candidate 2
CompId GroupAddress Group Mask RPAddress/Priority
2 224.1.0.0 255.255.0.0 20.0.0.1/192
It shows the Group addresses, the Group Mask and the RP address that indicates the
IP address of the Rendezvous Point (RP) for the listed PIM Sparse group.
Related Commands
rp-candidate rp-address – Enables the address of the interface, which will be advertised
as a Candidate-RP
rp-candidate holdtime – Sets the holdtime of the component when it is a candidate RP in
the local domain
rp-static rp-address – Sets the address of the interface, which will be advertised as a
Static- RP