Release : 1.1f 669 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.18 network
This command defines the interfaces on which OSPF runs and the area ID for those interfaces.
The no form of the command disables OSPF routing for interfaces defined and to remove the
area ID of that interface.
network <Network number> area <area-id> [unnum Vlan <PortNumber>]
no network <Network number> area <area-id> [unnum Vlan <PortNumber>]
Syntax Description
Network number - Network type
area - Area associated with the OSPF address range. It is specified as an IP address
unnum Vlan - VLAN id for which no ip address is configured
Mode
Router Configuration Mode
Example
SMIS(config-router)# network 20.0.0.1 area 20.0.0.0 unnum Vlan 1
When a more specific OSPF network range is removed, interfaces belonging to that network
range will be retained and remain active if and only if a less specific network range exists.
There is no limit to the number of network commands that can be used on the router
Related Commands
router ospf – Enables OSPF routing process
show ip ospf - database – Displays OSPF Database summary for the LSA type
show ip ospf interface – Displays OSPF interface information
To Next Page
Loading...
