Release : 1.1f 133 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
3.93 mac-address-table aging-time
This command sets the maximum age of a dynamically learnt entry in the MAC address table.
The no form of the command sets the maximum age of an entry in the MAC address table to its
default value.
mac-address-table aging-time <1-1000000 seconds>
no mac-address-table aging-time
Mode
Global Configuration Mode
Defaults
300
Example
SMIS(config)# mac-address-table aging-time 100
If traffic on an interface is not very frequent, then the aging time must be increased to record the
dynamic entries for a longer time. Increasing the time can reduce the possibility of flooding.
Related Command
show mac-address-table aging-time - Displays the MAC address-table ageing time
To Next Page
Loading...
