Release : 1.1f 945 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
33.23 show access-lists
This command displays the access lists configuration.
show access-lists [[{ip | mac}] <access-list-number (1-32768)> ]
Syntax Description
ip - IP Access List
mac - MAC Access List
Mode
Privileged/User EXEC Mode
Example
SMIS# show access-lists
SMIS# show access-lists ip 1
SMIS# show access-lists mac 1
Related Commands
ip access-list - Creates IP ACLs and enters the IP Access-list configuration mode
mac access-list extended - Creates Layer 2 MAC ACLs, and returns the MAC-Access
list configuration mode to the user
permit - standard mode - Specifies the packets to be forwarded depending upon the
associated parameters
deny - standard mode - Denies traffic if the conditions defined in the deny statement are
matched
redirect - standard mode - Redirects traffic if the conditions defined in the redirect
statement are matched
permit- ip/ospf/pim/protocol type - Allows traffic for a particular protocol packet if the
conditions defined in the permit statement are matched
deny - ip/ospf/pim/protocol type- Denies traffic for a particular protocol packet if the
conditions defined in the deny statement are matched
redirect - ip/ospf/pim/protocol type- Redirects traffic for a particular protocol packet
if the conditions defined in the redirect statement are matched
permit tcp - Specifies the TCP packets to be forwarded based on the associated parameters
deny tcp - Specifies the TCP packets to be rejected based on the associated parameters
To Next Page
Loading...
