Release : 1.1f 870 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
31.39 debug ipv6 ospf
This command sets the trace levels. The no form of the command resets the trace levels.
debug ipv6 ospf [pkt ( [{high | low | hex}] [hp] [ddp] [lrq] [lsu]
[lsa] )] [level ([fn_entry] [fn_exit] [critical] [mem_alloc_succ]
[mem_alloc_fail])] [module ( [ppp] [rtm] [nssa] [rt_aggrg]
[adj_formation] [lsdb] [ism] [nsm] [rt_calc] [interface] [config] )]
no debug ipv6 ospf [ pkt ( [{high | low | hex}] [hp] [ddp] [lrq] [lsu]
[lsa] )] [level ( [fn_entry] [fn_exit] [critical] [mem_alloc_succ]
[mem_alloc_fail] )] [ module ( [ppp] [rtm] [nssa] [rt_aggrg]
[adj_formation] [lsdb] [ism] [nsm] [rt_calc] [interface] [config] ) ]
Syntax Description
pkt - Packet High Level Dump debug messages
high - Packet High Level Dump Trace
low - Packet Low Level Dump Trace
hex - Packet Hex Dump Trace
hp - Hello packet Trace
ddp - DDP packet Trace
lrq - Link State Request Packet Trace
lsu - Link State Update Packet Trace
lsa - Link State Acknowledge Packet Trace
level - Trace Level Debug Messages
fn_entry - Function Entry Trace
fn_exit - Function Exit Trace
critical - Critical Trace
mem_alloc_succ - Memory Allocation Success Trace
mem_alloc_fail - Memory Allocation Failure Trace
module - OSPFv3 Module Debug Messages
ppp - Protocol Packet Processing Trace
rtm - RTM Module Trace
nssa - NSSA Trace
rt_aggrg - Route Aggregation Trace
adj_formation - Adjacency formation Trace
lsdb - Link State Database Trace
To Next Page
Loading...
