Release : 1.1f 732 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
27.24 bgp client-to-client reflection
This command configures the Route Reflector to support route reflection to Client Peers and the
no form of the command configures the Route Reflector not to reflect routes to Client Peers.
bgp client-to-client reflection
no bgp client-to-client reflection
Mode
Router Configuration Mode
Example
SMIS(config-router)# bgp client-to-client reflection
BGP Speaker Local AS number must be configured.
BGP Cluster-id must be configured.
By default, Route Reflector will reflect routes learnt from a client peer to all other client peers. If
required, administrator can disable this feature by disabling client-toclient reflection. If disabled,
then Route Reflector will not advertise routes learnt from a client peer to other client peers. This
occurs when all peers within a cluster are fully-meshed and the client peer itself is able to
advertise routes to other clients of the route-reflector
Related Commands
router bgp – Sets the AS number of the BGP Speaker
show ip bgp rfl info – Displays info about RFL feature
To Next Page
Loading...
