Supermicro SSE-G48-TG4 - Default Redistribute-Policy

Release : 1.1f 808 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
29.3 default redistribute-policy
This command sets the default behavior of the RRD6 Control Table.
default redistribute-policy {ipv6} {permit | deny}
Syntax Description
ipv6 - IPv6 Protocol
permit - Sets the default rule for all prefixes to 'permit'
deny - Sets the default rule for all prefixes to 'deny'
Mode
Global Configuration Mode
Example
SMIS(config)# default redistribute-policy ipv6 permit
Related Command
show redistribute-policy ipv6 – Displays route redistribution filters