Release : 1.1f 437 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
16.3.16 utilization threshold
This command sets the pool utilization threshold value in percentage. If the pool utilization
reaches this threshold level, a syslog event and an SNMP trap message will be generated. The
no form of this command sets pool utilization threshold to its default value.
utilization threshold { <integer (0-100)> }
no utilization threshold
Mode
DHCP Pool Configuration Mode
Defaults
75
Example
SMIS(dhcp-config)# utilization threshold 76
Related Commands
show ip dhcp server pools - Displays the DHCP server pools
logging - Enables Syslog server and configures the Syslog Server IP address, the log-level
and other Syslog related parameters
To Next Page
Loading...
