Supermicro SSE-G48-TG4 - Lldp Tlv-Select Dot1 Tlv

Release : 1.1f 974 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
36.13 lldp tlv-select dot1tlv
This command configures 802.1 VLAN tlv transmission on interface. It enables the transmission
of given tlv on any interface.
The no form of this command disables the transmission of given tlv on any interface.
lldp tlv-select dot1tlv {[port-vlan-id] [protocol-vlan-id {all |<vlan-
id>}] [vlan-name {all | <vlan-id>}]}
no lldp tlv-select dot1tlv {[port-vlan-id] [protocol-vlan-id {all
|<vlan-id>}] [vlan-name {all | <vlan-id>}]}
Syntax Description
port-vlan-id – Enables transmission of port vlan identifier tlv
protocol-vlan-id all - Enables transmission of all protocol vlan identifiers tlv
protocol-vlan-id <vlan-id> - Enables transmission of the given protocol vlan identifier tlv
vlan-name all - Enables transmission of all vlan names tlv
vlan-name <vlan-id> - Enables transmission of the given vlan name tlv
Mode
Interface Configuration Mode
Defaults
Disabled
Example
SMIS(config-if)# lldp tlv-select dot1tlv port-vlan-id protocol-vlan-id
all
Related Commands
show lldp local – Displays the LLDP local interface information.