Release : 1.1f 650 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
26.3 area - Stability interval
This command configures the Stability interval for NSSA and the no form of the command
configures default Stability interval for NSSA.
area <area-id> stability-interval <Interval-Value (0 - 0x7fffffff)>
no area <area-id> stability-interval
Syntax Description
area-id - Area associated with the OSPF address range. It is specified as an IP address
stabilityinterval - The number of seconds after an elected translator determines its
services are no longer required, that it must continue to perform its translation duties
Mode
Router Configuration Mode
Defaults
40
Example
SMIS(config-router)# area 10.0.0.1 stability-interval 10000
Area ID 0.0.0.0 is used for the OSPF backbone.
The OSPF Sequence Number is a 32 bit signed integer. It starts with the value
'80000001'h, -- or -'7FFFFFFF'h, and increments until '7FFFFFFF'h. Thus, a typical
sequence number will be very negative.
Related Command
show ip ospf info – Displays general information about OSPF routing process
To Next Page
Loading...
