Supermicro SSE-G48-TG4 - Set Ipv6 Pim Lan-Prune-Delay

Release : 1.1f 592 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
23.20 set ipv6 pim lan-prune-delay
This command sets the LanPruneDelay bit configured for the PIMv6 router interface to advertise
the Lan delay. The command specifies whether to use LAN prune delay or not.
set ipv6 pim lan-prune-delay { enable | disable }
Syntax Description
enable - Enables LAN-prune-delay
disable - Disables LAN-prune-delay
Mode
Interface Configuration Mode
Defaults
disable
Example
iss (config-if)# set ipv6 pim lan-prune-delay enable
Related Command
show ipv6 pim interface – Displays the PIMv6 interfaces of the router