Release : 1.1f 587 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
23.15 ipv6 pim componentId
This command adds the interface to the component.
ipv6 pim componentId <value(1-255)>
Mode
Interface Configuration Mode
Defaults
1
Example
iss (config-if)# ipv6 pim componentId 1
This command adds the current VLAN into the specified PIMv6 component.
Related Commands
set ipv6 pim – Enables or disables PIMv6 globally
show ipv6 pim component – Displays the component information
To Next Page
Loading...
