Release : 1.1f 717 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
27.12 neighbor - timers
This command configures neighbor KeepAlive Time and Hold Time Intervals and the no form of
the command resets neighbor KeepAlive Time and Hold Time Intervals.
neighbor <ip-address> timers {keepalive <seconds> | holdtime <seconds>}
no neighbor <ip-address> timers {keepalive | holdtime}
Syntax Description
ip-address - Peer IP address
timers - Timers.
keepalive - keep-alive interval for the peer session. The keep-alive value must always be less
than the configured hold-time value
holdtime - The hold-time interval for the peer . This is sent in the OPEN message to the peer
Mode
Router Configuration Mode
Defaults
Default keep-alive is one-third the value of the Default Hold-time.
Example
SMIS(config-router)# neighbor 23.45.0.1 timers keepalive 40
BGP Speaker Local AS number must be configured Peer must be created and peer AS must be
configured.
Related Commands
router bgp – Sets the AS number of the BGP Speaker
show ip bgp info – Displays the general info about BGP protocol
To Next Page
Loading...
