Release : 1.1f 614 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
24.7 vrrp - interval
This command sets the advertisement timer for a virtual router. The no form of the command sets
the advertisement timer for a virtual router to default value.
vrrp <vrid(1-255)> timer <interval(1-255)secs>
no vrrp <vrid(1-255)> timer
Syntax Description
vrid - Virtual Router ID
timer - The time interval, in seconds, between sending advertisement messages
Mode
VRRP Interface Configuration Mode
Defaults
1 second
Example
SMIS(config-vrrp-if)# vrrp 4 timer 6
Only the master router sends advertisements.
On expiry of the advertise timer, the Master sends advertisement packets to the Backup.
The command vrrp <vrid(1-255)> ipv4 <ip address> must be entered for the current
interface (with the proper vrid) before the execution of this command
Related Commands
router vrrp – Enables VRRP in the router
show vrrp – Displays the VRRP status information
To Next Page
Loading...
