Supermicro SSE-G48-TG4 - Ip Dvmrp Prune-Life-Time

Release : 1.1f 528 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
21.2 ip dvmrp prune-life-time
This command sets the prune life time value. The no form of the command sets the prune life
time to the default value (50 seconds).
ip dvmrp prune-life-time <time(1-7200secs)>
no ip dvmrp prune-life-time
Mode
Global Configuration Mode
Defaults
time - 50 seconds
Example
SMIS(config)# ip dvmrp prune-life-time 100
DVMRP must be enabled globally prior to the execution of this command.
Related Commands
set ip dvmrp – Enables / disables DVMRP in the switch
show ip dvmrp – Displays the DVMRP details