Release : 1.1f 584 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
23.12 ipv6 pim query-interval
This command sets the frequency at which PIMv6 hello messages are transmitted on the
interface. The no form of the command sets the default hello timer interval for the interface.
ipv6 pim query-interval <Interval (0-65535)secs>
no ipv6 pim query-interval
Mode
Interface Configuration Mode
Defaults
30
Example
iss (config-if)# ipv6 pim query-interval 60
The query message informs the presence of a PIMv6 router on the interface to the neighboring
PIMv6 routers.
Related Command
show ipv6 pim interface – Displays the PIMv6 interfaces of the router
To Next Page
Loading...
